11/29/2022 0 Comments Two gopro mimolive![]() Once you see it, it means that the GoPro is connected to your newly set up access point. You will see it in the list under Wireless Nodes. Once the access point has rebooted, go to Status tab and wait for the GoPro to connect to the access point. Now the DD-WRT access point will reboot to apply the new settings. #Two gopro mimolive passwordThen under that, you have to put your GoPro WiFi password phrase. Now click, on the Wireless Security tab and Choose WPA2 Personal as Security Mode. You will see a message that you have successfully joined the network.Īnother screen will appear under the Basic Settings tab showing the GoPro WiFi name, don’t change any setting here and just click save. Once you see your GoPro’s WiFi in the list, click on Join. Your GoPro should appear in the list, if it’s not then make sure it’s WiFi is ON then try again. Site survey will detect all the neighboring wireless networks, this will enable me to see the WiFi network of the GoPro. Once I’m logged in to the router, I go to “Status” then “Wireless”, then I click on “Site Survey”. I then login to the router, make sure the GoPro is turned on. I can test that I’m connected by pinging the Bridge Router IP address (you should already have this). I start by turning off the WiFi on my laptop, then I will connect the Bridge Router via an ethernet cable to my laptop. Let’s Jump to the Setup! Setting up the Bridge router Ok, so just before I start, as I said before, both routers should have DD-WRT firmware running on them or else it won’t be possible to have the configuration options I’m going to show you now. I will just walk you through the steps at a high level so you can understand what I will be doing.ġ- Configure the Bridge Router to run in Client Mode so it will act as a Bridge.Ģ- Configure the Home Router with a static route to allow traffic from the GoPro camera to the Home Router.ģ- Connect the Bridge Router to the back of the Home RouterĤ- Test GoPro connectivity and use Camera Suite for Live Preview I will then create a static route on the main router to allow traffic from the GoPro to the WiFi network.įor the sake of clarity, I am going to name the WiFi home router: Home Router and the other router: Bridge Router. The rest of the IP addresses will be different than mine, so your IPs will be different. The default IP address for the GoPro is 10.5.5.9. I’m gonna connect the DD-WRT router to the main router. You can always use a USB to ethernet adapter if you don’t have an ethernet port on your laptop.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |